Hey all, so this is the biggest thing I’ve tried to print. I’m using PETG. I’m getting a lot of repetitive bands of underextrusion that seem to stack up and get worse as the print progresses.

What do you think is causing this? Is this just an inherent thing in the way an Ender 3 works by moving the bed?

  • sharpiemarker@feddit.de
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 year ago

    Starting with the hotend too close to the bed?

    I had an ender 3 and never got it printing consistently. Level the bed, try again. Level the bed, try again. Ad nauseam. My recommendation would be to level the bed and try printing again.

  • macgyveringIt@lemmy.sdf.org
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    I recently had an issue that caused similar issues. Ended up being a bad wheel on the Z axis. Wheel was damaged and the carriage would move up and down as the Z axis traversed causing that stripped pattern.

    Good luck!

  • jelos98@lemmy.world
    link
    fedilink
    English
    arrow-up
    0
    ·
    1 year ago

    I second “not hot enough”. The PETG lists it’s ideal temp as 230 on the reel, but it seems to need closer to 245-250 or I get similar.

    • gordon@lemmy.worldOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      That’s too bad, I heard the ender really struggles with these higher temps.