As the title says, I found a recurring smudge in my photos when I was editing this one. You can see the smudge in the middle of the photo.

At first I thought it was on the outside of the lens, so I cleaned it off. Still there.

I ran the “clean image sensor” program on the camera. Still there.

So I detached the lens from my camera body and when looking through it with the aperture wide open, I could see the particle that was causing the smudges.

I then took a photo of a white wall with the flash on at the widest aperture setting I could (f/36) which I will be posting at the bottom of this post body. There the middle smudge and a smaller smudge in the lower left can be seen.

Is there anything I can do to resolve this? I can see there are 3 screws at the camera side of the lens that I might be able to unscrew, but I have no idea what’s inside or how complex it would be to pick apart. It wouldn’t surprise me if I just introduced more dirt by opening it up.

The smudge is very visible at any aperture setting greater than about f/6.

I appreciate any feedback.

Photo of a white wall:

    • hanke@feddit.nuOP
      link
      fedilink
      arrow-up
      2
      ·
      1 year ago

      Really? I mean… If the dust is on the sensor… Does it matter what aperture I use?

      • superkret@feddit.de
        link
        fedilink
        arrow-up
        2
        ·
        1 year ago

        Yes. I don’t know exactly why, but I’ve been shooting digitally for 15 years and have dealt with sensor dust a lot.
        I’d first clean the sensor with a swab and cleaning fluid, then test again before you do anything to the lens.

          • superkret@feddit.de
            link
            fedilink
            arrow-up
            2
            ·
            1 year ago

            No. Without a lens on, the picture is completely unfocused, so any dust spot will be “spread out” over the entire picture and not be visible.

            • hanke@feddit.nuOP
              link
              fedilink
              arrow-up
              2
              ·
              1 year ago

              Oh okay. Are there any more troubleshooting steps I can take to test this further, or is the sensor cleaning kit the next step?

              • superkret@feddit.de
                link
                fedilink
                arrow-up
                1
                ·
                1 year ago

                You can see where on the picture your dust spots are, so compare that to where in the lens you saw dust. Does it correspond?