Hi. Since yesterday i selfhosted all my stuff with a raspberry pi and two odroids. Everything works ok, but after i read about a few apps that are not supported by the arm-architecture of the SBCs and about the advantages of the backup-solution in proxmox, i bought a little server (6500T/8GB/250GB) to try proxmox.

Installed proxmox, but now - before i install my first VM - i have a few questions:

a) What Linux OS do i take? Ubuntu Server?

b) Should it be headless?

The server is in the cellar of my house, so would there be any advantages of installing an OS with a GUI?

  • cwagner@lemmy.cwagner.me
    link
    fedilink
    English
    arrow-up
    3
    ·
    edit-2
    1 year ago

    While it’s easier with LXCs, even with VMs, you have more granular backups for easier recovery.

    • thirdBreakfast@lemmy.world
      link
      fedilink
      English
      arrow-up
      3
      ·
      1 year ago

      I run one VM which some small docker containers go on, but whenever I’m trying something out it’s always in a Debian or Ubuntu VM - things just usually work easier. If it turns out to be a service I’m serious about running, then I’ll sometimes spend the time to set it up in it’s own LXC. Even a single Docker container.

      I much prefer each service in it’s own VM or LXC - for that same reason. Easier backups, easier to move to other nodes, easier to see the resources being used.

      @moddy with that processor and your 8GB you have plenty of room to play with multiple VM’s. Headless Ubuntu is probably the best place to start just because of the volume of results you get when googling issues. Enjoy.

      • moddy@feddit.deOP
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        Ok, i will have to check out what a LXC is before i start, but that helped a lot. Thanks

        • thirdBreakfast@lemmy.world
          link
          fedilink
          English
          arrow-up
          1
          ·
          1 year ago

          It’s a bit like docker, in that it’s a sort of isolated system, but you use it more like a virtual machine (VM). It’s lighter than a VM because it uses the host kernel so you can run lots of them with out consuming too many resources.

          In the Proxmox web interface, up in the top right corner there’s a “Create CT” button. If you click through all that (once again I am recommending Ubuntu) you’ll have your first LXC container up in a couple of minutes - the quick creating is another advantage over VM’s. One of the joys of your excellent choice of Proxmox as a base is that you can easily experiment with such things.