I’m trying to learn how to sharpen scissors. I’m using a draw-filing technique. I’m not sure where I’m doing right or wrong. Anyone has any input? It’s a little better than it was but it’s definitely not as sharp as it could be. Gonna try attach some pics.
It’s normal for scissors to have different angles on the thumb arm than the finger arm, depending on their intended use. You shouldn’t have to work the backs too much, but they should be revisited every so often during filing/honing to work the burr that is formed by the sharpening. I personally feel that a stone is more economical but you can finish hone with high grit automotive sandpaper too. If you’ve got an old leather belt, some scrap wood, and some glue you could make yourself a strop and only need some polishing compound. The finish work with a strop removes the burr, leaving the sharpened edge - if you don’t remove the burr your tool is likely to lose the edge more quickly.
Thank you. I meant on the same blade, the angle looked like it could be steeper at one end than at the other. But it seemed odd that it would come like that or wear like that over time? So maybe I was imagining it I’m not sure
I see what you mean - is it possible that you’re a “back third” cutter? I tend to cut close to the lever end of scissors and will have to touch that section up well before the point end needs any maintenance.