I have a local network where all the devices receive their ip from the router. IP range is 192.168.0.XXX.
On one of those machines i want to run “home assistant operating system” inside a VM using libvirt(using cockpit webgui).
I was able to install the VM, but when I run it, it never receives a IP address. Setting one manual works, but then the VM doesn’t show up in my local network.
On the host machine I created a bridge (virbr0) and I made the nic(enp8s0) from the host member. I also made VM member of virbr0
Any ideas what i’m doing wrong?
Note that the VM also needs to become member of the local network (ip range 192.168.0.XXX) and needs to see all other members of the local network.
Acronyms, initialisms, abbreviations, contractions, and other phrases which expand to something larger, that I’ve seen in this thread:
Fewer Letters More Letters HA Home Assistant automation software ~ High Availability IP Internet Protocol NAT Network Address Translation
3 acronyms in this thread; the most compressed thread commented on today has 5 acronyms.
[Thread #261 for this sub, first seen 3rd Nov 2023, 12:30] [FAQ] [Full list] [Contact] [Source code]
Could it be that you need to run the VM network in NAT mode, instead of a “Bridge” mode?
Please note, I have little experience in troubleshooting these, I’m just spitballing ideas here…
output from “nmcli device status” command:
DEVICE TYPE STATE CONNECTION
virbr0 bridge connected virbr0so i assume its in bridge mode?