I have been printing with PETG on glass for a little while now, and have gone through almost an entire roll. Yesterday I had my first print stick so hard that it delaminated the glass :(. I stopped using hairspray as it made the prints not stick at all, and printing bare glass was just fine. But something about yesterdays print made the glass give up. Is this how PETG + Glass normally fails? Works perfectly for years, and then suddenly fails?
Never tried Windex, but might give that a go. Gluestick had the same issue, lots of prints wouldn’t actually stick so I had lots of failures :/ I vaguely remember someone suggesting sugar water, so might try that as well.